This is an old revision of the document!

PearPC Control Panel

(page updated July 10, 2011)


The PearPC control panel is used to set up PearPC. Without it, the emulator must be launched at the command prompt.



Consult the PearPC setup guide for tips.

Check at the E-Maculation forum for support.


The PearPC Control Panel is sort of flakey. I highly recommend creating your own configuration file using Guillaume Jamet's online config file generator and launching the emulator from the command prompt.

You can also use the PearPC Virtualbox GUI.


pearpc1.jpg pearpc2.jpg pearpc3.jpg

pearpc_control_panel.1310266423.txt.gz · Last modified: 2011/07/09 19:53 by clockwise
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki