Emaculation.com
 

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
pearpc_networking_guide [2008/12/11 03:32]
clockwise
pearpc_networking_guide [2008/12/11 03:40]
clockwise
Line 11: Line 11:
 Getting online (and even communicating with your host machine) in PearPC is fun and easy!  There are just a few things you need to assemble beforehand: Getting online (and even communicating with your host machine) in PearPC is fun and easy!  There are just a few things you need to assemble beforehand:
  
-  * You should probably be using PearPC .5pre (redscorp).  There is a setup guide for that over [[pearpc setup|here]].+  * You should probably be using PearPC .5pre (redscorp), with the newest PearPC Control Panel.  There is a setup guide with downloads over [[pearpc setup|here]].
   * You need an IP address that is not in the range of 192.168.0.* (where * is between 1 and 254).  If your IP is within that range and you cannot change it, please check out an [[http://wiki.pearpc.net/index.php?title=Bridging_for_Windows_XP/Vista|alternate method]] of getting online.   * You need an IP address that is not in the range of 192.168.0.* (where * is between 1 and 254).  If your IP is within that range and you cannot change it, please check out an [[http://wiki.pearpc.net/index.php?title=Bridging_for_Windows_XP/Vista|alternate method]] of getting online.
   * You need to install [[http://openvpn.net/download.html|OpenVPN]] before you begin.   * You need to install [[http://openvpn.net/download.html|OpenVPN]] before you begin.
Line 28: Line 28:
 {{http://www.emaculation.com/pearpc/pearpcnetwork2.jpg}}\\  {{http://www.emaculation.com/pearpc/pearpcnetwork2.jpg}}\\ 
 **Figure Two:  Click the check-box** **Figure Two:  Click the check-box**
 +
 +Run the PearPC Control Panel.  Edit your existing configuration.  On the "Networking" part of the configuration screen, click "Use 3c90x" (if your emulated machine is booting OS X 10.3 or later) or "Use Realtek Card" (if your emulated Machine is booting OS X 10.2 or earlier).  Everything else can remain at the default settings.  Now save your configuration (and check out figure three).
 +
 +{{http://www.emaculation.com/pearpc/pearpcnetwork3.jpg}}\\ 
 +**Figure Three: Setting up the network settings in PearPC Control Panel** 
 +
  
  
pearpc_networking_guide.txt ยท Last modified: 2010/06/06 20:36 by clockwise
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki