Emaculation.com

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
pearpc_networking_guide [2008/12/11 03:32] clockwisepearpc_networking_guide [2008/12/11 05:43] clockwise
Line 9: Line 9:
 ===== Introduction ===== ===== Introduction =====
  
-Getting online (and even communicating with your host machine) in PearPC is fun and easy!  There are just a few things you need to assemble beforehand:+Getting online in PearPC is fun and easy!  There are just a few things you need to assemble beforehand:
  
-  * You should probably be using PearPC .5pre (redscorp).  There is a setup guide for that over [[pearpc setup|here]].+  * You should probably be using PearPC .5pre (redscorp), with the newest PearPC Control Panel.  There is a setup guide with downloads over [[pearpc setup|here]]
 +  * This guide is for use with PearPC booting **Mac OS X 10.3 and above**.  For tips on setting up internet connection sharing in Mac OS X 10.2, check out the [[http://wiki.pearpc.net/index.php?title=ICS_Networking_for_XP/Vista|original version]] of the guide.
   * You need an IP address that is not in the range of 192.168.0.* (where * is between 1 and 254).  If your IP is within that range and you cannot change it, please check out an [[http://wiki.pearpc.net/index.php?title=Bridging_for_Windows_XP/Vista|alternate method]] of getting online.   * You need an IP address that is not in the range of 192.168.0.* (where * is between 1 and 254).  If your IP is within that range and you cannot change it, please check out an [[http://wiki.pearpc.net/index.php?title=Bridging_for_Windows_XP/Vista|alternate method]] of getting online.
   * You need to install [[http://openvpn.net/download.html|OpenVPN]] before you begin.   * You need to install [[http://openvpn.net/download.html|OpenVPN]] before you begin.
Line 28: Line 29:
 {{http://www.emaculation.com/pearpc/pearpcnetwork2.jpg}}\\  {{http://www.emaculation.com/pearpc/pearpcnetwork2.jpg}}\\ 
 **Figure Two:  Click the check-box** **Figure Two:  Click the check-box**
 +
 +Run the PearPC Control Panel.  Edit your existing configuration.  On the "Networking" part of the configuration screen, click "Use 3c90x" (if your emulated machine is booting OS X 10.3 or later) or "Use Realtek Card" (if your emulated Machine is booting OS X 10.2 or earlier).  Everything else can remain at the default settings.  Now save your configuration (and check out figure three).
 +
 +{{http://www.emaculation.com/pearpc/pearpcnetwork3.jpg}}\\ 
 +**Figure Three: Setting up the network settings in PearPC Control Panel** 
 +