Emaculation.com
 

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
ubuntu [2018/03/10 23:33]
cat_7 [Introduction]
ubuntu [2018/03/11 01:37] (current)
cat_7 [Preparation]
Line 31: Line 31:
  
 We provide a pair of packages that were built on Ubuntu Intel/AMD 64 bit. Find them at our forum entry [[http://​www.emaculation.com/​forum/​viewtopic.php?​p=35420#​35420|SheepShaver for Linux]]. ​ There is a build that runs in full-screen (if you are experiencing bad mouse movement, check the forum notes). ​ And a build that runs in a window (the full-screen build crashes a lot when running in a window). ​ These builds are dated 03-09-2010. We provide a pair of packages that were built on Ubuntu Intel/AMD 64 bit. Find them at our forum entry [[http://​www.emaculation.com/​forum/​viewtopic.php?​p=35420#​35420|SheepShaver for Linux]]. ​ There is a build that runs in full-screen (if you are experiencing bad mouse movement, check the forum notes). ​ And a build that runs in a window (the full-screen build crashes a lot when running in a window). ​ These builds are dated 03-09-2010.
- 
-== Set memory access == 
-Due to a change in how programs in Linux are allowed to use memory, before using SheepShaver you need to set a variable in the file \\ 
-/​etc/​sysctl.conf \\ 
- 
-At the end of the file add this line: vm.mmap_min_addr = 0 
- 
-  Assuming you're using KDE, to edit sysctl.conf graphically just type: 
-  "kdesu kwrite /​etc/​sysctl.conf"​ into your run box (Alt + F2). 
- 
-  If you're using Gnome then: "gksu gedit /​etc/​sysctl.conf"​ 
  
  
ubuntu.txt ยท Last modified: 2018/03/11 01:37 by cat_7
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki