Darwin Install completes-Boot hangs on "IP Firewall Loa
Posted: Sat May 22, 2004 3:43 pm
After the Darwin install completed (using v0.1.1, rebooted PPC and it restarts, but hangs after displaying the following:
Darwin/BSD (localhost) (console)
login: IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging disabled
IPv6 packet filtering initialized, default to accept, logging disabled
IP Firewall loaded
(...hangs....)
Everything else went normal, as per the instructions. The only other thing I notice during booting (not sure if this is relevant) is a number of entries beginning with "waiting for...." but no error following multiple lines of "waiting for...."
Any help is greatly appreciated.[/img]
Darwin/BSD (localhost) (console)
login: IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging disabled
IPv6 packet filtering initialized, default to accept, logging disabled
IP Firewall loaded
(...hangs....)
Everything else went normal, as per the instructions. The only other thing I notice during booting (not sure if this is relevant) is a number of entries beginning with "waiting for...." but no error following multiple lines of "waiting for...."
Any help is greatly appreciated.[/img]