Browsing for .sea.bin files in Executor

[ClockWise]

Executor has proved itself to still be very useful after all these years.

I used the mini vMac setup guide located here:

http://minivmac.sourceforge.net/doc/start.html

And then I did this:

"Instead of a real Macintosh, you can use the program Executor, which can run some 680x0 Macintosh software without requiring any software from Apple. Though it is no longer developed or supported, it currently may be downloaded for free. It comes with StuffIt Expander 4.0.1 which can extract the program “SSW 6.0.8-1.4MB Disk1of2.sea” from “SSW_6.0.8-1.4MB_Disk1of2.sea.bin”, and then “SSW 6.0.8-1.4MB Disk1of2.sea” can be run to get the disk image “System Startup”."

However: I created my HFV to use in Executor, but the Executor browser would not show the two original files when I browsed for them.

I had to use HFVExplorer to add them to the image I was using within Executor.

What gives? Why wouldn't they show up in the browser?